Coolant Immerssion Heater; Transmission Oil Heater - New Holland T7030 Operator's Manual

COOLANT IMMERSION HEATER
WARNING
To avoid shocks or other injuries, never use an
unearthed or inadequate extension lead with the
coolant or oil heater. Always use an earthed, three
core extension lead, which is rated for at least a 15
amp load, in conjunction with a residual current
circuit breaker or earth leakage trip device.
This accessory consists of a heating element fitted
into one of the core plug apertures on the right--hand
side of the block. The heater is available in 115 or 230
volts A.C only. This accessory provides easier
starting down to --29° C (--20° F).
To operate the heater, connect the heater extension
cable to the socket (1) adjacent to the right--hand cab
steps. Plug the free end of the heater cable into a
suitable electrical outlet for up to four hours before
carrying out the cold weather starting procedure.

TRANSMISSION OIL HEATER

This accessory consists of a 115 or 230 volts A.C.
heating element installed in the transmission
housing. Connect the heater extension cable to the
plug (1) on the left side of the rear axle housing. This
accessory provides for faster warm up of the
transmission/hydraulic oil when operating in cold
climates.
To operate the heater, connect the plug on the free
end of the heater cable to a suitable 115 volt outlet
(using a voltage transformer, if necessary) for up to
four hours before starting the engine.
NOTE: The coolant or transmission oil heaters may
be left plugged in for more than four hours without
harm. However, no noticeable increase in the
heater's effectiveness will be achieved after this
period.
SECTION 6 - - ACCESSORIES
5
6
6--3