Every 600 Hours; Engine Oil Change; Diesel Fuel Sulphur Content; Operation 18 - Engine Oil And Filter - New Holland T7030 Operator's Manual

EVERY 600 HOURS carry out the
preceding checks plus the following:

ENGINE OIL CHANGE

IMPORTANT: Operation 22 depicts the normal 600
hour engine oil and filter change period. However,
the oil change period may be affected by other
factors:
Cold Temperature Operation
Engines operating in temperatures below - - 12 ° C
(10 ° F) or in arduous conditions should have the oil
changed every 300 hours of operation. (The oil filter
need only be changed at the normal 600 hour service
interval).

Diesel Fuel Sulphur Content

In some countries, locally available diesel may have
a high sulphur content, in which case the oil and filter
change period should be adjusted, as follows:
Sulphur content between 0.5 and 1.0%
•
- - change engine oil every 300 hours.
Sulphur content between 1.0 and 1.3%
•
- - change engine oil every 150 hours.
OPERATION 18
ENGINE OIL AND FILTER
Warm the engine to operating temperature. Stop the
engine, remove the drain plugs (1) Figure 61 and
catch the oil in a suitable container. Unscrew and
discard the oil filter (1).
WARNING
Be very careful to avoid contact with hot engine oil.
If the engine oil is extremely hot, allow it to cool to a
moderately warm temperature before proceeding.
To change the oil and filter:
1. Remove the engine oil drain plugs which are
located at the rear of the sump on either side of
the engine. Catch the oil in a suitable container
and dispose properly.
2. Replace the drain plugs after the oil has drained.
SECTION 4 - - LUBRICATION AND MAINTENANCE
61
4--33