Using The Auto P.t.o. Function - New Holland T7030 Operator's Manual

Using the Auto P.T.O. Function (where fitted)
The Auto P.T.O. function provides automatic
engagement or disengagement of the rear P.T.O.
drive when using the EDC raise/lower switch (1).
Operating the switch to raise the implement will
automatically disengage P.T.O. drive. Lowering the
implement with the switch will re--engage P.T.O.
drive.
The height at which the P.T.O. is engaged or
disengaged can be set using the following method.
IMPORTANT: The tractor must be stationary and the
P.T.O. switched off before attempting this procedure.
With the engine running and the P.T.O. switched
•
off, operate the lift control to capture the hitch.
Depress and hold the P.T.O. switch for 2
•
seconds. The central display will show 'u'
followed by two figures, for example, 'u38'. The
figure 38 representing the current height of the
hitch.
Raise the hitch to point at which the P.T.O. is to
•
disengage. Depress the P.T.O. switch once, the
central display will show 'd xx' (where 'xx' is the
current height of the hitch).
Lower the hitch to the point where the P.T.O. is
•
to re--engage and depress the P.T.O. switch
again. The central display will show 'End' for two
seconds and then return to the option selected
prior to entering set--up mode.
Providing the tractor is stationary and the P.T.O. is
disengaged, this procedure can be carried out at any
time. The new settings will remain in the memory until
re--programmed.
To activate the Auto function, engage the P.T.O. as
previously described and then depress and hold the
switch (1), for more than one second. The Auto
P.T.O. lamp on the instrument panel will illuminate to
confirm activation.
3--36
SECTION 3 - - FIELD OPERATIONS
47
48