After Refilling The System - All Coolant Solutions; Coolant Capacity; Clean Water Specification; Chemical Inhibitor - New Holland T7030 Operator's Manual

After Refilling the System - - All Coolant
Solutions
1. Inspect cooling system hoses and connections
for leaks.
2. Fill the coolant recovery tank to the cold fill mark
(1).
3. Start the engine and run it until normal operating
temperature is reached.
NOTE: The coolant level will drop as coolant is
pumped around the system.
4. Stop the engine and allow the coolant to cool.
5. Remove the radiator cap (1) Figure 91 and add
coolant to the radiator to bring the coolant level
to the bottom of the filler neck. Install the radiator
cap. Add coolant to the recovery tank as required
to bring the level up to the cold mark (2).
NOTE: If the engine is not going to be operated
immediately following this coolant change, run the
engine for one hour to ensure that the antifreeze
and/or chemical inhibitor is dispersed throughout the
cooling system. Allow the engine to cool and make
a final check to ensure that the coolant level is
satisfactory.

Coolant Capacity

All models

Clean Water Specification:

Total Hardness
Chlorides
Sulphates
Antifreeze:
Ambra Agriflu Anti--Freeze (NH 900A) is available
from your authorised dealer in the following
quantities.
Part No. 2715 1502
2715 1900
2715 1100
SECTION 4 - - LUBRICATION AND MAINTENANCE
26.0 litres
(6.9 U.S. gal.)
300 parts per million
100 parts per million
100 parts per million
(4x5 litre)
(20 litre)
(200 litre)

Chemical Inhibitor

There are three part numbers for the inhibitor. The
content of each bottle is identical, only the
instructions on the label differ, by language:
Part No.
83958743
83958744
83958745
Languages on Label
English, French, Spanish,
Portuguese and Greek
English, French, German,
Italian and Dutch
English, Danish, Norwegian,
Finnish and Swedish
90
91
4--49