Instrument Panel Displays; Dot Matrix Display (Dmd); Liquid Crystal Displays; Rear Wheel Slip - New Holland T7030 Operator's Manual

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION

INSTRUMENT PANEL DISPLAYS

IMPORTANT: On tractors equipped with the optional
Intelliview II Monitor, a number of displays and
setting procedures will change. Consult the
Intelliview II Monitor Operator's Manual for details.
DOT MATRIX DISPLAY
A number of tractor operating and set--up functions
may be shown in the Dot Matrix Display (DMD). To
select a function use the CAL/SEL button or the
Enhanced Keypad (where fitted). A symbol will
appear to confirm the function selected.
If an error occurs in the instrument panel or tractor
systems circuits, a malfunction warning symbol will
appear in this display accompanied by an error code.
Consult your authorised dealer.

LIQUID CRYSTAL DISPLAYS

The information displayed in the centre LCD, will vary
depending on tractor specification. Use the CAL/SEL
switch or Enhanced Keypad (where fitted) to toggle
between the displays.
The following information may be displayed in the
centre LCD.
1. Rear wheel slip (with radar option only)
2. Power Take Off speed (front or rear)
3. 3--point hitch position (front or rear)

Rear Wheel Slip

If your tractor is equipped with optional ground speed
radar, the percentage (%) of rear wheel slip may be
displayed. The slip figure is calculated from
information provided by the transmission speed
sensor (theoretical ground speed) and the radar (true
ground speed).
74
75
76
2--39