Operating With Engine Speed Management; Accessing A Previously Stored Setting; To Exit Engine Speed Management - New Holland T7030 Operator's Manual

SECTION 3 - - FIELD OPERATIONS

Operating with Engine Speed Management

The Engine Speed Management function can be
engaged at any time providing the engine is running
above 1000 r.p.m. Momentarily depress the Speed
Control switch (2) to activate ESM. The system will
automatically default to programme 1, depress the
bottom of the control switch to select programme 2.
When operating in the field, shuttling between
programmes 1 and 2 may be achieved by repeatedly
depressing the bottom of the control switch or, if
more convenient, the Headland Turn Sequence step
switch (3) Figure 12.
11
NOTE: If the HTS step switch is used to shuttle
between ESM speeds, the control switch (2),will be
disabled. To re- -enable switch operation, exit and
re- -enter the ESM function.
NOTE: Moving the hand throttle in ESM mode will
disable the speed settings and return engine speed
control to the hand or foot throttle.

Accessing a Previously Stored Setting

To access a previously stored speed setting, depress
and hold the top of the ESM switch (2), Figure 11.
The indicator light will start to flash in the instrument
panel.
NOTE: The hand throttle must be set to 1000 e.r.p.m.
before depressing the switch.
Continue to hold the switch until the light stops
flashing and goes out, the engine speed will increase
or decrease to the previously stored setting. Depress
the bottom of the control switch (2) or the HTS switch
12
(1) to select the required ESM programme.
NOTE: If the ESM switch (2) is released whilst the
light is flashing, Engine Speed Management will
reset to the default setting, depress and hold the
ESM switch again to re- -start the procedure.

To exit Engine Speed Management:

Depress the ESM control switch.
Move the hand throttle to idle.
Turn the key--start to the off position.
3--12