Connecting And Operating Single-Acting Cylinders; Connecting And Operating Continuous Flow Hydraulic Equipment - New Holland T7030 Operator's Manual

Connecting and Operating Single-Acting
Cylinders
Connect the hose (1) from a single-acting cylinder to
the lower coupler (2) on the remote control valve, as
previously described.
To extend a single-acting cylinder, pull the control
lever rearwards, to the 'raise' position.
Manually return the lever to the neutral position to
stop the cylinder before it is fully extended or allow
the valve to return to the neutral automatically when
the cylinder reaches the end of it's stroke.
To retract a single-acting cylinder, move the lever
fully forward, to the 'float' position.
IMPORTANT: Always use the 'float' position to lower
a single-acting cylinder. The 'lower' position is for
double-acting cylinders only.
Connecting and Operating Continuous Flow
Hydraulic Equipment
Continuous flow hydraulic equipment (e.g. hydraulic
motors) should be connected to the remote control
valve coupler with the feed hose (1) connected to the
upper coupler (4) and the return hose (2) connected
to the lower coupler (3) of the same valve.
SECTION 3 - - FIELD OPERATIONS
115
116
117
3--73