SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION
Accessing Stored Error Codes
Using the CAL/SEL button
Depress and hold the CAL/SEL button for three
•
seconds to enter SETUP MENU, after two
seconds the display will change to CAL. Using
the clock set buttons H and M to toggle the
display, select the the active warning symbol (1),
Figure 110.
Depress the CAL/SEL button and the active
•
symbol will be replaced with a symbol
corresponding to the fault detected.
If more than one warning symbol has been
•
stored, the display will cycle through each one in
turn. After the fault symbols have been
displayed, the screen will default back to the
active warning symbol.
Momentarily depress the dimming button to exit
•
the display.
Using the Enhanced Keypad
With the key--start in the ON position, depress
•
and hold the Menu/Enter key (2) for 3 seconds.
The DMD will read SETUP MENU, this will
change to CAL after 2 seconds. Using the Menu
Up key (1), scroll through the menu until the
active warning symbol (1) Figure 112, is
displayed.
By momentarily depressing the Menu/Enter key
•
again, the active symbol will be replaced with a
symbol corresponding to the fault detected.
If more than one non--active symbol has been
•
stored, the display will cycle through each one in
turn. After the fault symbols have been
displayed, the screen will default back to the
active warning symbol.
Touch the Exit/Cancel key to exit and return to the
original display.
110
111
112
2--59