Control Pod; Edc Panel - New Holland T7030 Operator's Manual

Control Pod

The thumbwheel (5), when rotated, will move the
adjustable stop (1).
The position control lever (2), is used to set
implement height, when operating in Position
Control. Use it to set the maximum implement depth
when operating in Draft Control.
The draft loading wheel (3), determines the draft load
and therefore implement working depth by setting a
force on the draft sensitivity pins. Selecting position
10 will provide maximum load and therefore
maximum implement depth.
The raise/lower switch (4) Figure 83, is a three
position, spring centred switch that enables the
operator to rapidly raise the implement to the position
set by the height limit control and to lower the
implement back down to the working depth/height
set by the Position or Draft Controls, without
disturbing the settings. The switch also provides for
faster ground engagement, if required. For detailed
information, see text on page 3--64.

EDC Panel

The draft sensitivity control (1), is used to make the
system more sensitive or less sensitive to changes
in draft loading. Maximum sensitivity is obtained by
rotating the control fully clockwise.
The drop rate control (2), adjusts the speed at which
the three--point hitch drops during the lowering cycle.
Position 1 selects the slowest drop and is denoted by
the tortoise symbol, position 7 provides the fastest
rate of drop.
The height limit control knob (3), limits the height to
which the hitch may be raised. Adjust this knob to
avoid the possibility of a large implement damaging
the tractor when fully raised.
The slip limit control knob (4), available only with the
optional radar sensor unit, enables the operator to
select a wheel slip threshold, above which the
implement will raise until wheel slip returns to the set
level.
3--58
SECTION 3 - - FIELD OPERATIONS
83
84