Operating In Automatic Mode - New Holland T7030 Operator's Manual

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION

Operating in Automatic Mode

To engage both front and rear differential locks in
automatic mode, depress the top of the switch (1).
The warning light in the switch will illuminate. The
indicator light (1) Figure 149 on the instrument panel
will also illuminate but will only remain lit while the
differential locks are engaged.
In automatic mode, disengagement of the locks will
occur as follows:
Fast raise switch
activated (to raise the
rear 3- -point hitch)
Either brake pedal is
applied
Both brake pedals are
applied simultaneously
Tractor speed exceeds
15 Km/h (9 MPH)
Front steering angle
exceeds pre- -set limits
(where fitted)
Momentarily depress the
top of the differential lock
rocker switch
NOTE: If the differential lock is active when the
key- -start is turned off, it will remain active when the
key- -start is switched on again.
2--88
Temporary
disengagement (will
re- -engage when 3- -point
hitch is lowered
Temporary
disengagement
Differential lock remains
engaged
Differential locks will
permanently disengage
Temporary
disengagement (will
re- -engage when
steering angle is
reduced)
Differential locks will
permanently disengage
148
149