STOPPING THE ENGINE
IMPORTANT: Before stopping, idle the engine at
1000 rev/min for approximately one minute. This will
allow the turbo- -charger and manifold to cool and
prevent possible distortion of components.
To stop the engine, carry out the following procedure:
Sit in the driver's seat.
•
Close the throttle.
•
Ensure that the parking brake is firmly applied.
•
Ensure the P.T.O. is disengaged.
•
Place the remote control valve levers in the
•
neutral position.
Lower 3 point hitch mounted equipment to the
•
ground.
Turn the key--start switch off -- position (2).
•
AUTOMATIC ENGINE SHUTDOWN
IMPORTANT: Before attempting to start an engine
that has automatically shutdown, trace and rectify
the fault that caused the engine to be stopped.
Automatic engine shutdown is operated through the
electronic engine controller (ECU). In the unlikely
event that one or more of the following conditions
occurs then the engine will be shut down after 30
seconds.
A critical error is detected within the engine
•
electronic control system.
The generated engine horsepower attempts to
•
exceed the specified design limit.
Should either of the above occur and the engine
shuts down, consult your authorised dealer before
attempting further operations with the tractor.
NOTE: Automatic engine shutdown function is
permanantly activated and cannot be switched off.
3--8
SECTION 3 - - FIELD OPERATIONS