Two-Speed, Shiftable Pto (540/1000 Or 540E/1000) - New Holland T7030 Operator's Manual

TWO- -SPEED, SHIFTABLE P.T.O.
(540/1000 or 540E/1000)
A 6--spline P.T.O. output shaft of 1.375 in. (34.9 mm)
diameter is supplied, designed to operate at 540
rev/min.
Dependent upon tractor specification, an alternative
21--spline shaft of 1.375 in. (34.9 mm) diameter,
designed to operate at 1000 rev/min., may also be
supplied with the tractor or is available from your
dealer.
An alternative 20--spline shaft of 1.75 in. (44.45 mm)
diameter, designed to operate at 1000 rev/min., is
available from your dealer.
Operating
Before engaging the P.T.O., select a P.T.O. ratio, as
follows:
With 6- -spline shaft installed
With the tractor stationary and the P.T.O. control
•
knob in the disengaged position, select the
required speed by means of the range lever (1).
Lift the spring-loaded collar (2) beneath the knob
and move the lever to engage 540, 540E or 1000
P.T.O. speeds.
IMPORTANT: The P.T.O. range lever cannot be
moved until the spring-loaded collar beneath the
knob is lifted.
With 21- -spline shaft installed
With the tractor stationary and the P.T.O. control
•
knob in the disengaged position, lift the
spring-loaded collar (2), beneath the knob, and
move the lever (1) fully to the right. This will
provide a P.T.O. speed of 1000 rev/min at 2178
engine rev/min.
NOTE: The P.T.O. range lever should always be in the
1000 rev/min position when the 21- -spline shaft is
installed. If you only ever operate with a 21- -spline
shaft, leave the range lever in this position.
SECTION 3 - - FIELD OPERATIONS
40
41
3--33