Sliding Type Swinging Drawbar - New Holland T7030 Operator's Manual

Sliding Type Swinging Drawbar

The drawbar (2) pivots about a single pin at the front
end so as to allow the rear of the drawbar to swing
the full width of the hanger. By inserting the swing
limiter pins (1) in the appropriate holes, restricted
movement of the drawbar is permitted. Alternatively,
the drawbar can be pinned in any one of three
positions by insertion of the pins in the appropriate
holes. In Figure 167, the drawbar is shown pinned
in the central position to prevent swinging.
Pin the drawbar to prevent swinging when pulling
equipment which requires accurate positioning and
when transporting equipment.
Allow the drawbar to swing when pulling ground
engaging equipment which does not require
accurate positioning. This will make steering and
turning easier.
WARNING
When transporting equipment or when operating
ground engaging equipment, always secure the
drawbar to prevent swinging.
The drawbar is adjustable for height and projection
relative to the end of the P.T.O. shaft. To vary the
height of the drawbar/implement hitch point, remove
the drawbar and invert it.
All Countries Except North America
The front securing pin may be inserted in one of three
holes in the drawbar to vary the P.T.O. shaft to hitch
point distance. See Figure 168 and the following
table:
Hole (see P.T.O. Shaft to
Fig. 168) Drawbar Hitch Point
Drawbar clevis uppermost
1 406 mm (16 in.)
2 356 mm (14 in.)
3 243 mm (9.6 in.)
Drawbar clevis underneath
1 406 mm (16 in.)
2 356 mm (14 in.)
3 243 mm (9.6 in.)
SECTION 3 - - FIELD OPERATIONS
Maximum Static
Downward Load
1440 kg (3175 lb.)
1680 kg (3700 lb.)
2575 kg (5675 lb.)
1045 kg (2300 lb.)
1225 kg (2700 lb.)
1305 kg (2875 lb.)
167
168
3--107