Panhard Rod Pivot (suspended 4WD axle)
Apply a grease gun to the lubrication fitting, as
shown.
Suspension Arm (suspended 4WD axle)
Apply a grease gun to the lubrication fitting at the rear
of the suspension arm, located beneath the tractor,
in front of the transmission.
Drive Shaft Universal Joint (suspended and
Supersteer axles only)
Apply a grease gun to the lubrication fitting, as
shown.
NOTE: The grease fittings shown is at the rear of the
drive shaft. On some models, the shield completely
covers the drive shaft and a hole is provided for
access.
4WD Steering Cylinders and Track Rods
Apply a grease gun to the lubrication fittings, as
shown (Supersteer axle illustrated).
NOTE: The left-hand end of the axle is shown. There
are similar grease fittings on the left-hand steering
cylinder and track control rod.
SECTION 4 - - LUBRICATION AND MAINTENANCE
38
39
40
41
4--23