Internal Filter
To remove an internal filter, loosen the retaining
screws (1) anti clockwise and remove the filter cover.
Remove the cover (1) and extract the filter from the
housing.
NOTE: The filter (2) is made of specially treated
media with a rubber sealing strip bonded to the upper
surface. Take care not to damage the element during
removal.
Clean the elements by blowing with compressed air
not exceeding 30 lbf. in
the clean surface through the element to the dirty
side. Hold the nozzle at least 12 in. (300 mm) from
the element to prevent damage to the filter media.
SECTION 4 - - LUBRICATION AND MAINTENANCE
2
(2 bar). Blow the dust from
25
26
4--19