Recording A Programme - New Holland T7030 Operator's Manual

Recording a Programme

NOTE: For HTS to function, the hand throttle must
be set to provide an engine speed above 900 e.r.p.m.
IMPORTANT: If the tractor is stopped or no controls
used for approximately 13 minutes when recording
a sequence, the system will automatically revert to
standby and any steps recorded will be lost.
To record a Headland Turn Sequence, depress and
hold the top of the record switch (2), for three
seconds. This will activate HTS but the system will
remain in standby mode.
The HTS symbol will appear in the upper part of the
display accompanied by the recording symbol which
will start to flash.
To start recording, momentarily depress the step
switch (3). As each HTS linked control is operated,
a grey coloured symbol will appear in the display
immediately below the recording symbol.
As each symbol moves down the display to be
replaced by the next one, the colour will change from
grey to black.
NOTE: Symbols relating to the function in current
use, either in record or play- -back mode, will always
appear inversed (grey symbol on black background).
After the first HTS sequence has been completed, a
second (opposite headland) sequence may be
recorded.
Depress and hold the step switch (3) for three
seconds to end the first recording and enter standby
mode. The recording symbol will start to flash.
To start recording a second sequence, momentarily
depress the step switch (3).
NOTE: Transmission shifts made whilst the tractor is
in reverse will not be recorded or played back by
HTS. A pause will be automatically entered in the
programme at this point.
3--18
SECTION 3 - - FIELD OPERATIONS
16
17