Wheel Adjustment; Wheels With Steel Centre Disc Bolted To Flange On The Rim - New Holland T7030 Operator's Manual

WHEEL ADJUSTMENT

The sectioned drawings shown in Figures 223, 224 and 225 illustrate the wheel rim and disc positions at various
track settings. In each table, two track width settings are quoted for each axle type. These are the minimum and
maximum achievable with both wheel assemblies moved fully in (toward the tractor) and fully out (away from
the tractor).
Track Adjustment
2490 mm axle (98 in.)
1524 -- 1828 mm (60 -- 72 in.)
2845 mm axle (112 in.)
1524 -- 2184 mm (60 -- 86 in.)
3022 mm axle (119 in.)
1524 -- 2388 mm (60 -- 94 in.)
2490 mm axle (98 in.)
1727 -- 2032 mm (68 -- 80 in.)
2845 mm axle (112 in.)
1727 -- 2388 mm (68 -- 94 in.)
3022 mm axle (119 in.)
1727 -- 2590 mm (68 -- 102 in.)
2490 mm axle (98 in.)
1930 -- 2235 mm (76 -- 88 in.)
2845 mm axle (112 in.)
1930 -- 2540 mm (76 -- 100 in.)
3022 mm axle (119 in.)
1930 -- 2744 mm (76 -- 108 in.)
2490 mm axle (98 in.)
2133 -- 2438 mm (84 -- 96 in.)
2845 mm axle (112 in.)
2133 -- 2794 mm (84 -- 110 in.)
3022 mm axle (119 in.)
2133 -- 2998 mm (84 -- 118 in.)

Wheels with steel centre disc bolted to flange on the rim

NOTE: With the larger width tyres, it may not be
possible to move the wheels to the narrower settings
due to limited clearance between the tyre and fender.
SECTION 3 - - FIELD OPERATIONS
Rim and Disc Position
NOTE: The track widths shown in Figure 223 are
nominal and may vary from that shown dependent on
wheel and tyre size.
223
3--139