Stopping The Unit; Stopping The Engine - New Holland WORKMASTER 35 Operator's Manual

STOPPING THE UNIT

Stopping the engine

To stop the engine, carry out the following procedures:
1. Remain in the operator seat.
2. Pull the hand throttle lever rearward to the idle posi-
tion.
3. Engage the park brake.
4. Ensure all gear shift levers, range levers or shuttle shift
lever are in the neutral position and the PTO switch is
in the "OFF" position.
5. Push the hydraulic power lift (HPL) control lever for-
ward to lower implements to the ground.
6. Turn the key to the "STOP" position to shut the engine
off.
NOTE: When the key is turned to the "STOP" position
and the park brake is NOT engaged, an alarm will sound.
The alarm will continue to sound for approximately ten
seconds or until the park brake is engaged.
NOTE: If the key is not left in the "STOP" position after
the engine has stopped, the warning lights will remain on
and discharge the battery.
4 - OPERATING INSTRUCTIONS
4-16