Removing/installing main
46 50
stand/side stand
Disassembling and assembling
46 53
side stand
•
Disengage the tension springs and take off the
plate with the springs.
–
Remove switch for side stand (arrow)
(
61.16).
a
•
Remove the side stand.
•
Installation is the reverse of the removal proce-
dure.
e
Important:
Install screw and nut with Loctite 243.
Lubricant:
for bushing .................................. Shell Retinax EP2
X
Tightening torque:
Side stand to pivot mount
(clean thread + apply Loctite 243) ................ 41 Nm
Switch to side stand
(clean thread + apply Loctite 243) .................. 9 Nm
46.20
Removing/installing pivot mount
46 52
with centre (main) and side stands
–
Remove the seat (
–
Remove the engine spoiler (
–
Remove engine spoiler holder (
•
Secure lifter, BMW No. 00 1 510, to oil sump.
•
Raise the motorcycle until the centre stand can
move freely.
•
Disconnect the cable tie, disconnect the plug for
the side stand switch and guide the cable
through downwards.
KR460260
•
Remove the screws (arrows) holding the pivot
mount.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torque:
Pivot mount to gearbox ................................ 41 Nm
Removing/installing main (centre)
46 52
stand (
a
52.5).
a
46.14).
a
46.14).
a
00.71)
KR460250