Checking Tightness Of Rear Wheel Studs; (Inspection I); Checking Rear Wheel Bearing Play By Tilting Wheel; (Inspection Iii) - BMW k 1200 rs Repair Manual

Checking tightness of rear
36 00
wheel studs

(Inspection I)

•
Tighten the rear wheel studs with a torque
wrench.
X
Tightening torque:
Studs for rear wheel ................................... 105 Nm
Checking rear wheel bearing
36 00
play by tilting wheel

(Inspection III)

•
Tilt the rear wheel to and fro across its axle.
Checking swinging arm bea-
33 00
rings, adjusting if necessary

(Inspections I and III)

•
Grip the rear wheel by the tyre and attempt to
move it sideways, while holding the grap handle
with your other hand.
•
Tighten bearings if there is perceptible play
( 33.24).
a
[Option without BMW Integral
33 00
ABS] Cleaning inductive signal
transmitter at rear wheel
Clean the inductive sensor at the rear wheel
every 40,000 km (24,000 miles) or every 2 years
at the latest

(Inspections III and IV)

•
Remove the screw (arrow).
•
Lever out the inductive sensor and clean it with a
cloth.
•
Installation is the reverse of the removal proce-
dure.
KR000020
00.73