Checking/Adjusting Fully-Assembled Length Of Output Shaft - BMW k 1200 rs Repair Manual

23 4 762
0,2
23 4 763
A
23 4 761
1
23 00 Checking/adjusting fully-assembled
length of output shaft
e
Important:
Check and adjust the fully assembled length as de-
scribed below and install a spacing washer of the
correct thickness.
Before measuring, always make sure that the
grooved ball bearings are pressed fully home, even
if the shaft has not been disassembled and reas-
sembled.
•
Pull off the input-side grooved ball bearing with
universal puller, BMW No. 00 7 500.
•
Remove the spacing washer.
•
Position dial gauge, BMW No. 23 4 762, in rear
locating bore of stand, BMW No. 23 4 761, and
set to 0.2 mm (0.0079 in) preload.
•
Using dial gauge, zero to dimension "A" of the
zero gauge, BMW No. 23 4 763.
•
Place reference washer, BMW No. 23 4 766, on
the output shaft.
•
Place the grooved ball bearing on the reference
washer.
•
Insert the output shaft into the measuring stand.
23 4 766
2
•
Using the dial gauge, measure the deviation from
zero of dimension "B" at the inner bearing race.
Deviation from zero is equivalent to the thickness
"C" of spacer (1).
•
Place spacer (1) of correct thickness on
inner bearing race and check deviation from
zero.
A = B + C
e
Important:
The maximum deviation from zero must not be ex-
ceeded.
•
Take off spacing washer, grooved ball bearing
and reference washer.
•
Place a spacing washer (1) of the correct thick-
ness on the output shaft and press on the
grooved ball bearing.
Reference dimension for input shaft:
The maximum permissible deviation from zero
is ..................-0.05 ... 0.00 mm (-0.0019...0.000 in)
Fully assembled length
............ 192.95 ... 193.00 mm (7.5964...7.5984 in)
1
B
3
C
KR230300
23.21