•
Very gently press the handbrake lever until the
pump just starts up.
•
Open the bleed screw at the left-hand brake cal-
iper.
•
Pump the brake fluid at virtually no pressure until
the hose is full of brake fluid.
•
Position the end of the hose on the
cover, BMW No. 34 2 541.
•
Pump the brake fluid with virtually no pressure to
begin with, then vary the brake pressure.
d
Warning:
The brake fluid must not foam in the hose.
If this should happen, follow the procedure for
bleeding/changing brake fluid in the front wheel cir-
cuit (
00.45).
a
•
Pump brake fluid through the system until it is
clear and free from air bubbles.
•
Close the bleed screw.
•
Release the handbrake lever.
•
Disconnect silicon hose, BMW No. 34 1 560,
from bleed screw and drain its contents into
wheel circuit reservoir.
•
Connect silicon hose, BMW No. 34 1 560, to
bleed nipple of right brake caliper.
•
The procedure for bleeding the right brake cali-
per is the same as that for the left caliper.
•
Close the bleed screw.
•
Release the handbrake lever.
•
Switch off the ignition.
•
Disconnect silicon hose, BMW No. 34 1 560,
from bleed screw and drain its contents into
wheel circuit reservoir.
•
Remove cap, BMW No. 34 2 541.
34.22
e
Attention:
After changing and/or bleeding the brakes, always
top up the fluid in the wheel-circuit reservoir to the
correct level in accordance with the instructions.
•
Fill front wheel-circuit reservoir with brake fluid in
accordance with instructions (
•
Perform a function check on the brake system
with the ignition switched on.
e
Attention:
After all the work on the brake system has been
completed, run a bleed test using the
BMW MoDiTeC!
•
Perform bleed test with BMW MoDiTeC
(
00.35).
a
Brake fluid ...................................................DOT 4
X
Tightening torque:
Bleed screw to brake caliper .......................... 7 Nm
00.47).
a