1
•
Attach locking arm (1).
2
3
•
Insert outer race (2).
•
Coat threaded ring (4) with Loctite 577.
•
Tighten threaded ring (4) with pin wrench,
BMW No. 33 1 700.
•
Oil thrust ring (5) lightly and place in position.
L
Make sure that the lip of the shaft seal is seated
correctly on the thrust ring.
•
•
e
33 1 720
The nut must not damage shaft sealing ring (3).
•
33 1 700
X
Threaded ring
KR330060
(clean thread + apply Loctite 577) .............. 118 Nm
Nut for input bevel gear
(clean thread + apply Loctite 2701) ............ 200 Nm
Housing cover .............................................. 35 Nm
4
5
6
KR330370
Clean the threads of hex nut (6) and input bevel
pinion.
Coat the thread of hex nut (6) with Loctite 2701.
Important:
Tighten hex nut (6) with 36 mm (1.4173 in) socket
wrench insert and reducing adapter,
BMW No. 33 1 720.
Tightening torque:
33.13