Checking and adjusting the
00 00
motorcycle
Checking the function of side
00 00
stand contact switch
•
Switch off the engine.
•
Place motorcycle on its centre stand.
•
Select a gear and switch on the ignition.
–
Temperature gauge warning light lights up.
•
Extend the side stand, observing the tempera-
ture gauge warning light.
–
Temperature gauge warning light goes out (en-
gine control unit switches off).
Checking the headlight beam set-
00 00
ting and adjusting if necessary
Vertical adjustment
L
Note:
Set the pivot lever only in the centre position (neutral
position).
•
Pivot lever (1) is in centre position.
•
Adjust headlight beam throw with adjusting
screw (2).
Anti-clockwise rotation: ............ longer throw/higher
Clockwise rotation:................... shorter throw/lower
•
Adjust beam throw with a suitable adjuster.
Setting for headlight beam angle adjuster
...................................................-10 cm (-3.937 in)
00.26
Setting for headlight beam
............................................. x = -10 cm (-3.937 in)
............................. H = Bulb centre normal position
.................. (basic spring setting, not pretensioned)
Pivot lever (1):
Centre position ...............................neutral position
Bottom position........................for heavy loads only
1
Lateral adjustment
2
41630010
•
Adjust left/right angle at screw (3).
KR630080
3
KR630060