Figure 1-14 Powering Off The Workstation; Figure 1-15 System Shutdown Notifier - Silicon Graphics Tezro Hardware User's Manual

1: Installation and Operation Procedures
16
Figure 1-14 Powering Off the Workstation
Within a few seconds, a shutdown notifier appears, as shown in Figure 1-15. Within
a minute, the system powers off automatically.
Figure 1-15 System Shutdown Notifier
3. Turn off your monitor by pressing the monitor power button.
If your system does not power off and you do not see any activity for several
minutes, press the power button again.
Note: If you press the power button a second time, the system should power off
immediately, but this method does not perform a clean shutdown. Avoid using this
method unless the system does not respond for several minutes after you first press
the power button.
If pressing the power button a second time does not work, use a pen to press the
reset switch, shown in Figure 1-16. If the system still fails to power off, unplug the
power cable from the rear of your workstation and contact your service provider.
007-4564-001