User's Manual
To connect the DC Power Supply when using a DC terminal block
crimp connector, take these 3 steps:
1.
Remove the DC adaptor (screw connection type) that is attached to the Mediant
2000 rear panel.
2.
Connect the two insulated wires to the correct DC power supply. Ensure that the
connections to the DC power supply maintain the correct polarity (refer to the
figure below).
3.
Insert the terminal block to the DC inlet located on the Mediant 2000.
The Mediant 2000 hardware installation is now complete.
3.3.1.3
Mediant 2000 Rear Views with Connected Cables
The figures below display the Mediant 2000 rear view with connected cables.
Figure 3-10: Rear View with Connected Cables (16 Spans and Dual AC)
2
1
Version 5.0
Figure 3-9: DC Power Connector - Crimp Type
3
3
1
4
43
3. Hardware Installation
5
June 2006