AudioCodes Mediant 2000 User Manual page 280

Error Message Text
PSTNAutoClockEnable is
relevant only when Recover
clock from PSTN and
TDMBusClockSource is
%d.',ImageBoardParams.TDM
BusClockSource"
PSTN Trunk Validation Check
Warning - no such TDM bus
clock source.'
Warning: ISDN is Network side
and you have requested clock
from the PSTN Network.'
"'acl_iua_config() - duplicate
Int_id =%d,on Trunk =
%d.',ImageBoardParams.Ext.I
UATrunkConfig[TrunkId].IuaInt
erfaceId,TrunkId"
"'acl_dua_config() - duplicate
Int_id =%d,on Trunk =
%d.',ImageBoardParams.Ext.I
UATrunkConfig[TrunkId].IuaInt
erfaceId,TrunkId"
Framing method is not
supported in Ultra mapper.'
IsdnValidation - Cannot add
another variant - configuration
failed. Reached maximum
ISDN variants number.'
"PSTN Validation Check failed
- Line Type must be E1 or T1
for Trunk number = %d. Please
change the protocol type.',i"
PSTN Validation Check failed.
TDMBusClockSource is
Internal and all trunks
ClockMaster are
acCLOCK_MASTER_OFF.
Change the
TDMBusClockSource to
Network or ClockMaster to
acCLOCK_MASTER_ON.'
User's Manual
Table 9-3: User Error Messages
Probable Cause
from external devices (=3 ||
>7), which means that all
trunks should be at master
mode, but also configure
"TDMBusPSTNAutoClockEn
able"(=1), means recover the
clock from one of the trunks.
User configured
TDMBusClockSource to an
un-none value.
ISDN is Network side and
you have requested clock
from the PSTN Network.
IUA configuration error - IUA
interface ID value has been
duplicated.
DUA configuration error -
DUA interface ID value has
been duplicated.
User configured TP-6310 to
work with one of the
following T1 framing
methods: A,B,E,F,N.
Cannot add another variant -
configuration failed. Reached
maximum ISDN variants
number.
User configured all trunks
with "ProtocolType" NONE
(=0).
User configured
TDMBusClockSource to be
"internal" (=1) , which means
that trunks should be at
master mode, but you
configured all trunks'
"PSTNClockMaster" to
"acCLOCK_MASTER_OFF"
(=1),
280
Mediant 2000
Recommended Action
board.
Set "TDMBusClockSource" to be
a valid value (0, 1, 3, 4, 8-22) and
reset the board.
Set the trunk configuration
parameter "PSTNClockMaster "
to "acCLOCK_MASTER_ON"
(=1).
Remove IUA interface.
Remove DUA interface ID that
has been duplicated.
Set the framing method to one of
the valid methods with TP-6310
(C,D) and reset the board.
The current SW version supports
up to 4 different ISDN variants
simultaneously.
Set at least one trunk with a
protocol type and reset the board.
Set all the trunks'
"PSTNClockMaster " to
"acCLOCK_MASTER_ON" (=1)
and reset the board. Alternatively
you can set
"TDMBusClockSource" to
"Network" (4).
Document # LTRT-69805