Backward Compatibility; Defining Field Width In The Termination Name; Termination Mapping To A Pstn Interface - AudioCodes Mediant 2000 User Manual

Note also that for trunking gateways, the 'TrunkName' can NOT be null. The default
values for the Termination name parts for Trunking boards is the default gateway
name, 'tgw/'; the default trunk name is 's' and the default Endpoint name is '/c'. So the
Termination that represents B-channel 1 of trunk 0 is 'tgw/s0/c1'.
PSTN Interface - mapping Trunk/B-channel pairs to Endpoints is hardware-specific
(refer to the table, ''MEGACO EndPoint Names'' on page 161.) Note that the number
of supported terminations per Mediant 2000 is equal to the channel density of the
Mediant 2000.
LOGICALRTPTERMPATTERN = "gwrtp/*"
7.2.10

Backward Compatibility

The connection between the old naming parameters and the new ones is done by
creating the name pattern from the old name parameters. Let's assume for example
that the old name parameters are:
GATEWAYNAME = "gw"
TRUNKNAME = "s"
ENDPOINTNAME = "chan"
This is equivalent to the following new name parameters:
PHYSTERMNAMEPATTERN = "gws*chan*"
LOGICALRTPTERMPATTERN = "gwrtp/*"
7.2.11

Defining Field Width in the Termination Name

As explained above, a field is defined in a pattern by using '*'. If defining a fixed width
for this field is needed, a leading zero should be used in the pattern definition. The
possible width options are 1 or 2 characters. Therefore, only one leading zero is
supported. For example:
Pattern is "gws0*chan0*" - In this format, the name for trunk 1 and channel 1 is
"gws01chan01", and the name for trunk 1 channel 12 is "gws01chan12".
Pattern is "gws*chan*" - In this format, the name for trunk 1 and channel 1 is
"gws1chan1", and the name for trunk 1 channel 12 is "gws1chan12".
7.2.12

Termination Mapping to a PSTN Interface

The table below describes the mapping between Endpoints and channels for a PSTN
interface, according to the interface type used. The table below assumes the following
initial values:
Channel density - 60
Gateway name = 'Acgw/'
Trunk name = 'T'
Endpoint name = '/C',
The table below lists only the names for a two trunks unit.
User's Manual 160
Mediant 2000
Document # LTRT-69805