AudioCodes Mediant 2000 User Manual page 312

ini File Parameter Name
EnableIPAddrTranslation
EnableLANWatchdog
EnableMultipleIPs
EnableNTPasOAM
User's Manual
Table 11-3: Infrastructure Parameters
Description
Specifies the type of
compare operation
performed on the first packet
that is received on a newly
opened channel for the
Network Address Translation
(NAT) feature. If set to 1, the
board compares the first
incoming packet's source IP
address, to the remote IP
address stated in the
opening of the channel. If the
two IP addresses do not
match, the NAT operation
takes place. Consequently,
the remote IP address and
the UDP port of the outgoing
stream are replaced by the
source IP address and UDP
port of the first incoming
packet.
0 = Disable
1 = Enable for RTP, RTCP,
T38
2 = Enable for Aggregation
3 = Enable for ALL
Detects LAN failures on the
board. A LAN failure can
result from a software or
hardware malfunction. If a
LAN failure is detected, the
board performs a self reset
(when not in PCI mode).
0 = Disable
1 = Enable
Enables the multiple IPs
feature.
0 = Disable
1 = Enable
Sets the location of the
Network Time Protocol
(NTP). If this parameter is
set and the machine is
functioning in multiple IPs
mode, the NTP is located on
the OAM network. If not, the
312
Host/Manual
Default Value Valid Range
1 0 to 3
0 0 or 1
0 0 or 1
1 0 or 1
Document # LTRT-69805
Mediant 2000