AudioCodes Mediant 2000 User Manual page 294

ini File Parameter Name
DNSPriServerIP
DNSSecServerIP
EnableParameters
Monitoring
EnableSTUN
EnableSyslog
EnableTLSHW
EtherDiscoverMode
User's Manual
Table 11-1: System Parameters
Description
default access level for the
device. Default value is
'Security Administrator'
(=200).
This parameter defines the
DNS primary server's IP
address.
Range = Legal IP address
This parameter defines the
DNS secondary server's IP
address.
Range = Legal IP address
This parameter is used to
enable monitoring of on-the-
fly parameter changes via
Syslog messages.
1 = Activate
0 = Deactivate (default)
This parameter is used to
enable the STUN module,
used for NAT traversal of
UDP packets.
This parameter is used to
enable the Syslog protocol
log.
1 = Activate
0 = Deactivate
Used to enable hardware
acceleration for TLS
(SIPS/HTTPS...). Note:
enabling this parameter may
result in channel capacity
degradation (same as IPsec)
Controls EtherDiscover
mode of operation.
0 = Always disable
EtherDiscover
1 = Enable EtherDiscover if
unconfigured; allow changes
to IP configuration (default)
2 = Always enable
EtherDiscover, but do not
294
Host/Manual
Default Value Valid Range
0.0.0.0 See Descr.
0.0.0.0 See Descr.
0 0 or 1
0 0 or 1
0 0 or 1
1 0, 1, 2
Document # LTRT-69805
Mediant 2000