Mounting The Mediant 2000 On A Desktop; Mounting A Mediant 2000 In A 19-Inch Rack; Figure 3-4: 2000 System Rear Connectors (50-Pin Telco Connectors & Dual Ac Power); Table 3-3: Mediant 2000 Rear 16-Span Details - AudioCodes Mediant 2000 User Manual

User's Manual
Figure 3-4: 2000 System Rear Connectors (50-Pin Telco Connectors & Dual AC power)
1
4
Item # Component
1 Screws
2 TP-1610 RTM
3 Blank Panel
4 Ethernet Ports
5 Trunk Connections
6 Earthing Connection
7 Dual AC Connections
3.2.1

Mounting the Mediant 2000 on a Desktop

No brackets are required. Optionally, attach the four (supplied) anti-slide bumpers to
the base of the Mediant 2000 and place it on the desktop in the position you require.
3.2.2

Mounting a Mediant 2000 in a 19-inch Rack

The device can be installed in a standard 19-inch rack either by placing the device on
a shelf preinstalled in the rack (preferred method), or by attaching the device directly
to the rack's frame via integral brackets.
Before rack mounting the chassis, attach the two (supplied) brackets to the front sides
of the device (refer to the figure below).
Version 5.0
2
3
5

Table 3-3: Mediant 2000 Rear 16-Span Details

Description
cPCI board locking screws
16-Span Rear Transition Module
An available cPCI slot for an optional third-party Rear
Transition Module
Two RJ-45 Ethernet Port Interfaces
Two 50-Pin Telco Female Cable Connectors
Earthing Connection Screw
Dual 3-Pin AC Power Cable Connectors
1
5 6
37
3. Hardware Installation
7
June 2006