Cabling The Mediant 2000; Connecting The E1/T1 Trunk Interfaces - AudioCodes Mediant 2000 User Manual
Mgcp, megaco, tpncp voip mediant media gateways
Hide thumbs
Also See for Mediant 2000:
- User manual (702 pages) ,
- Installation manual (44 pages) ,
- Hardware installation manual (30 pages)
Table of Contents
Advertisement
User's Manual
Note:
The distance between the two rear screws is 26.5 mm.
To attach the rear brackets use 4-40 UMC screws.
To place the device on a 19-inch rack's shelf take these 2 steps:
1.
Place the device on the shelf.
2.
Follow the steps (optional) for fastening the device to the frame of the rack (as
described above) while it is placed on the shelf. This prevents the device from
sliding when inserting cables into connectors on the rear panel.
3.3
Cabling the Mediant 2000
The unit must be permanently connected to earth via the screw provided at
the back on the unit. Use 14-16 AWG wire and a proper ring terminal for the
earthing.
To cable the Mediant 2000, take these 4 steps:
1.
Permanently connect the device to a suitable earth with the protective earthing
screw on the rear connector panel, using 14-16 AWG wire.
2.
Connect the E1/T1 trunk interfaces (refer to "Connecting the E1/T1 Trunk
Interfaces" below).
3.
Install the Ethernet connection (refer to 'Installing the Ethernet Connection' on
page 41).
4.
Connect the power supply (refer to 'Connecting the Power Supply' on page 41).
3.3.1
Connecting the E1/T1 Trunk Interfaces
The Mediant 2000 is available in a number of configurations, i.e., AC or DC, in the 16-
trunk, 8-trunk, 4-trunk, 2-trunk or 1-trunk device. The 16-trunk dual AC and the 8-trunk
DC configurations are illustrated here as representative products.
For the 16 span configuration, refer to 'Connecting the E1/T1 Trunk Interfaces' on
page
For the up to 8- span configuration, refer to 'Connecting the E1/T1 Trunk
Interfaces - Up to 8-Span Configuration with RJ-48c Connectors' on page
the rear panel cables and cabling procedures.
To connect the E1/T1 Trunk interfaces with 50-pin Telco
connectors (16-trunk device), take these 3 steps:
1.
Attach the Trunk cable with a 50-pin male Telco connector to the 50-pin female
Telco connector labeled "Trunks 1 to 8" on the Rear Transition Module (RTM).
Version 5.0
Users assembling the rear brackets by themselves should note the
following:
Electrical Earthing
39
for the rear panel cables and cabling procedures.
39
3. Hardware Installation
40
for
June 2006
Advertisement
Table of Contents
