Dc Power Supply Module - AudioCodes MediaPack Series Hardware Installation Manual

CHAPTER 3 Physical Description
Item
#
2 Power cord anchor clip.
3 3-Prong power inlet.
4 LED for indicating power status. For more information, see
page 16 .
5 Handle for extracting and installing module.
The two Power Supply modules installed in the chassis must be of the same hardware
revision. For more information, see the note in on page 50.

DC Power Supply Module

For the DC-powered model, the device provides two DC Power Supply modules for load
sharing and power redundancy.
Power surge protection, caused for example from lightning, is also supported. For more
information, see
The Power Supply module is available as a spare part. The Power Supply modules are hot-
swappable and therefore, if only one needs to be replaced, it can be done while the device is
receiving power from the working Power Supply module. For replacing Power Supply modules,
see on page 50 .
Item #
1
2
3
Grounding and Surge Protection
Figure 3-11: DC Power Supply Module
Table 3-11: DC Power Supply Module Description
Release latch for releasing and securing module from / to chassis slot.
DC power inlet.
Handle for extracting and installing module.
MP-1288 | Hardware Installation Manual
Description
on page 19 .
Description
- 13 -
Power Supply LED on