AudioCodes Mediant 2000 User Manual page 300

ini File Parameter Name
DCHConfig
DIGITALPORTINFO
DisableTrunkAfterReset
DPNSSBehavior
User's Manual
Table 11-2: PSTN Parameters
Description
Clock Source)
Defines D-channel
configuration. This setting is
only applicable to ISDN PRI
protocols that support NFAS
and/or D-channel backup
procedures.
0 = D-channel is Primary
1 = Backup
2 = NFAS
Digital Port information
identifier (a user-defined
string).
Disables a Trunk - The trunk
behaves as if it is not
physically connected, i.e., it
enters mode of: no transmit
on that Trunk.
Used to change the
transmission state of the
PSTN physical device.
Enable, Disable (Tri state) or
Send Blue Alarm.
0 = Trunk Enabled
1 = Trunk Disabled
The DPNSSBehavior
parameter represents a Bit
field parameter. Each bit
represents a specific type of
DPNSS behavior. Currently
only the first 2 bits are in use.
DPNSS_BEHAV_STOP_SA
BMR_AFTER_NL_AND_NT1
bit: (bit #0, bit mask 0x0001)
When set to 1: DPNSS stops
repeating SABMR after NL
and NT1 limits are exceeded.
When set to 0: DPNSS
continues repeating SABMR
after NL and NT1 limits are
exceeded.
Default is 0 (continue
repeating SABMR)
DPNSS_BEHAV_FULL_STA
300
Host/Manual
Default Value Valid Range
0 0 to 2
0 All
0 0 or 1
0 See Descr.
Document # LTRT-69805
Mediant 2000