Verifying The Vlans And Multiple Ip Settings Using The Embedded Web Server - AudioCodes Mediant 2000 User Manual

User's Manual
The interface networks are designated as follows:
0-OAM
1-Call Control
2-Media
According to the sample parameters shown in the table above, the Routing table in the
ini file appears like this:
The following is an example of the Routing Table parameters
(according to the sample parameters shown in the table above) in
the ini file:
RoutingTableDestinationsColumn = 130.33.4.6, 83.4.87.6
RoutingTableDestinationMasksColumn = 255.255.255.255 ,
255.255.255.0
RoutingTableGatewaysColumn = 10.32.0.1 , 10.31.0.1
RoutingTableInterfacesColumn = 1 , 0
RoutingTableHopsCountColumn = 20,20
Each row of these parameters in the ini file is a column in the table of Routing Table
Rules.
5. Set the EnableMultipleIPs parameter to 1. The following is an example of this
parameter in the ini file:
EnableMultipleIPs=1
6. Save the changes to the ini file.
7. If your Mediant 2000 is using a software version earlier than 4.6, use BootP to
burn the updated cmp version to the non -volatile flash memory (-fb option in the
BootP application).
8. Reset the Mediant 2000. The updated ini file is implemented. The board has all
the required information to enable the advanced VLAN and IP separation
features.
9. To re-establish its network infrastructure, reset the Mediant 2000 again.
23.5 Verifying the VLANS and Multiple IP Settings
Using the Embedded Web Server
For details on using the Embedded Web Server, refer to ''Embedded Web Server'' on
page 187.
Version 5.0
23. Appendix - Getting Started with VLANs and Multiple IPs
521 June 2006