ProLiant MicroServer Remote Access Card
This document provides instructions for installing the remote access card in your HP ProLiant
MicroServer. This option allows users to perform server access tasks remotely over a LAN or the
Internet. The connector is shown in the figure below.
Installation guidelines
The procedures in this document are intended for individuals who are qualified in the servicing of
computer equipment and trained in recognizing hazards in products with hazardous energy levels.
WARNING:
removing or installing hardware components may cause serious damage as well as bodily harm.
WARNING:
installed hardware component to cool before touching them.
CAUTION:
Observe ESD safety precautions when handling any hardware component.
IMPORTANT:
Pre-installation procedure
Perform data backup.
1.
Turn off the server and all the peripherals connected to it.
2.
Unplug all cables from the power outlets to avoid exposure to high energy levels that may cause
3.
burns when parts are short circuited by metal objects such as tools or jewelry. If necessary, label
each cable to expedite reassembly.
Disconnect telecommunication cables to avoid exposure to shock hazard from ringing voltages.
4.
Follow the ESD safety precautions listed in
5.
Service Guide when handling any hardware component.
Failure to properly turn off the server before you open the server or before you start
To reduce the risk of personal injury from hot surfaces, allow the chassis and any
Observe the pre-installation procedure before installing the IPMI card.
your
HP ProLiant MicroServer's Maintenance and
Removal and replacement procedures 52