Enable/Disable Remote Access - HP 9000 Series Service Manual

Remote Management/Access Port Card

Enable/Disable Remote Access

This section provides the information on enabling or disabling the remote access through the internal
modem.
NOTE
The following procedures are only applicable if HP Predictive has not been installed. If
HP predictive is installed, use Predictive to configure the internal modem for remote
access. Refer to the Predictive Support User's Guide (part number 50779-90018).
HP-UX Remote Access
The process for the HP-UX HP 9000 systems is provided through a script called dialin. The syntax for
running the dialin script is:
>dialin [-bbaud] action
Where:
dialin - is the HP-UX script.
[-baud] - can be used to specify a baudrate (do not change the default baud rate).
action - is one of three choices: enable, disable, or status.
Example of enable remote access:
>dialin enable (this enables remote access and uses the default baudrate)
or
>dialin status (this displays the current status, either disabled or enabled)
CAUTION Do not use a baud rate other than the default of 19200 KBS. Other baud rates could
cause the dialin process to malfunction
12-12 Chapter 12