Disabling Ldp Auto-Configuration - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Label Distribution Protocol
Command or Action
Step 4
mpls ldp auto-config
Example:
RP/0/RSP0/CPU0:router(config-ospf-ar)# mpls
ldp auto-config
Step 5
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-ospf-ar)#
interface pos 0/6/0/0
RP/0/RSP0/CPU0:router(config-ospf-ar-if)
Step 6 Use the commit or end command.
Related Topics
IGP Auto-configuration, on page 17
Configuring LDP Auto-Configuration: Example, on page 56
Disabling LDP Auto-Configuration, on page 45

Disabling LDP Auto-Configuration

Perform this task to disable IGP auto-configuration.
You can disable auto-configuration on a per-interface basis. This lets LDP enable all IGP interfaces except
those that are explicitly disabled.
OL-28381-02
Purpose
Enables LDP auto-configuration.
Enables LDP auto-configuration on the specified interface. The
LDP configurable limit for maximum number of interfaces does
not apply to IGP auto-config interfaces.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
• No—Exits the configuration session without committing the
• Cancel—Remains in the configuration mode, without
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Disabling LDP Auto-Configuration
configuration session.
configuration changes.
committing the configuration changes.
45