Configuring Ldp Igp Synchronization: Ospf - Cisco ASR 9000 Series Routing Configuration Manual

Configuring LDP IGP Synchronization: OSPF

Configuring LDP IGP Synchronization: OSPF
Perform this task to configure LDP IGP Synchronization under OSPF.
By default, there is no synchronization between LDP and IGPs.
Note
SUMMARY STEPS
1. configure
2. router ospf process-name
3. Use one of the following commands:
4. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2
router ospf process-name
Example:
RP/0/RSP0/CPU0:router(config)# router ospf 100
Step 3 Use one of the following commands:
• mpls ldp sync
• area area-id mpls ldp sync
• area area-id interface name mpls ldp sync
Example:
RP/0/RSP0/CPU0:router(config-ospf)# mpls ldp sync
Step 4
commit
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
480
• mpls ldp sync
• area area-id mpls ldp sync
• area area-id interface name mpls ldp sync
Implementing OSPF
Purpose
Identifies the OSPF routing process and
enters OSPF configuration mode.
Enables LDP IGP synchronization on an
interface.