Mpls Te For Ospf Version 2: Example - Cisco NCS 6000 Series Configuration Manual

MPLS TE for OSPF Version 2: Example

Area 6 sets the cost to 30, which is inherited by GigabitEthernet interfaces 0/1/0/3 and 0/2/0/3. GigabitEthernet
interface 0/3/0/3 uses the cost of 1, which is set in interface configuration mode.
router ospf 1
router-id 10.5.4.3
cost 5
area 0
!
area 1
!
area 4
!
area 6
!
MPLS TE for OSPF Version 2: Example
The following example shows how to configure the OSPF portion of MPLS TE. However, you still need to
build an MPLS TE topology and create an MPLS TE tunnel. See the MPLS Configuration Guide for Cisco
NCS 6000 Series Routersfor information.
In this example, loopback interface 0 is associated with area 0 and MPLS TE is configured within area 0.
interface Loopback 0
address 10.10.10.10 255.255.255.0
!
interface GigabitEthernet 0/2/0/0
address 10.1.2.2 255.255.255.0
!
router ospf 1
router-id 10.10.10.10
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
336
interface GigabitEthernet 0/1/0/0
!
interface GigabitEthernet 0/2/0/0
!
interface GigabitEthernet 0/3/0/0
!
cost 15
interface GigabitEthernet 0/1/0/1
!
interface GigabitEthernet 0/2/0/1
!
interface GigabitEthernet 0/3/0/1
!
interface GigabitEthernet 0/1/0/2
cost 20
!
interface GigabitEthernet 0/2/0/2
!
interface GigabitEthernet 0/3/0/2
!
cost 30
interface GigabitEthernet 0/1/0/3
!
interface GigabitEthernet 0/2/0/3
!
interface GigabitEthernet 0/3/0/3
cost 1
!
Implementing OSPF