Configuring MPLS-TE Forwarding Adjacency
Command or Action
Step 4
Use the commit or end command.
Configuring MPLS-TE Forwarding Adjacency
Perform this task to configure forwarding adjacency on a specific tunnel-te interface.
SUMMARY STEPS
1. configure
2. interface tunnel-te tunnel-id
3. forwarding-adjacency holdtime value
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
interface tunnel-te tunnel-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
tunnel-te 1
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
192
Purpose
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters MPLS-TE interface configuration mode.
Implementing MPLS Traffic Engineering
OL-28381-02