Scan Edges Programming - Icom IC-9100 Instruction Manual

Memory channels 1A–3A and 1b–3b are the Program
Scan Edge channels. They are used to program the
upper and lower frequency edges for programmed
scans. (p. 149)
Each frequency band has its own Scan Edge chan-
nels. Factory default frequency and operating modes
are programmed into the Scan Edge channels.
If both upper and lower band edges are programmed
with the same frequency, a programmed scan can-
not start.
Programming 14.00000 MHz into 1A and
14.35000 MHz into 1b.
q Push [VFO/MEMO] to select the VFO mode.
w Rotate [M-CH] to select scan edge 1A.
e Set 14.00000 MHz as the lower frequency.
r Hold down [MW] for 1 second to program
14.00000 MHz into scan edge 1A.
plete.
t Rotate [M-CH] to select scan edge 1b.
y Set 14.35000 MHz as the upper frequency.
u Hold down [MW] for 1 second to program
14.35000 MHz into scan edge 1b.
plete.
i If 1A/1b is selected as the scanning range when a
programmed scan is started, it will search for sig-
nals between 14.00000 MHz and 14.35000 MHz.
(p. 149)
-
Programming 14.00000 MHz into 1A
M1
A G C D U P
-
Programming 14.35000 MHz into 1b
M1
A G C D U P
SCANS
[VFO/MEMO] [MW]
[M-CH]
C O M P T B W S C P
C O M P T B W S C P
11
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
148