Calling A Specific Station; Making A Call To An Individual Station Through Local Area Repeater - Icom IC-9100 Instruction Manual

8
DV MODE OPERATION
This section describes how to call a specific station
using the DR mode.
When the Link repeater (R2) is set to "GW," the des-
ignated gateway repeater is automatically set as the
Link repeater, and you can make a call to a specific
station through the internet.
q Set your own call sign.
w Hold down [DV DR] for 1 second to select the DR
mode.
The last used access repeater is displayed.
- If the displayed frequency band on the SUB Band is
the same as that of the last used access repeater, se-
lecting the DR mode on the MAIN Band will automati-
cally move the frequency band on the SUB Band to
the Main Band display, and turn OFF the SUB Band
display.
e Rotate [MAIN DIAL] to select the desired access
repeater.
(pp. 90, 100)
r Push [UR](F-4) to enter the UR call sign selection
mode.
t Rotate [MAIN DIAL] to select a individual station
call sign.
(U01–U99)
nient.
y Hold down [UR](F-4) for 1 second to enter the Link/
Gateway repeater (R2) selection mode.
q
MY call sign
JA3YUA
u Rotate [MAIN DIAL] to select "NOT USE ."
i Push [UR](F-4) to exit the Link repeater (R2) selec-
tion mode.
o Push [PTT] on the microphone to transmit. (or
[TRANSMIT] on the transceiver)
!0 Release [PTT] to receive. (or push [TRANSMIT]
again)
If you want to save this temporary setting, push [MW]
to enter the memory select write mode. (p. 102)
103
, whose "R1USE" setting is set to
are displayed.
station call sign memory groups
Zone
w e
Area
Repeater q NARA43
Station call sign
JG3YMK
-
[TRANSMIT]
r
(JP3YHL)
MAIN Band TX/RX indicator
D1
CS
]
[D
[UR] [MW]
R : N O T U S E
2
C D R > C S U R
NOT USE
[MAIN DIAL]
[MAIN DIAL]
DSET