1
PANEL DESCRIPTION
Front panel (continued)
!3 MENU SWITCH [MENU] (p. 19)
Push to change the set of functions assigned to
switches ([F-1] to [F-5]).
(Menu 1), M2 (Menu 2), M3 (Menu 3), D1 and D2.
Hold down for 1 second to enter the Set mode.
Push to return to the previous screen display.
!4 NOISE REDUCTION LEVEL CONTROL [NR]
Rotate to adjust the DSP noise reduction level
when the noise reduction function is in use. Set for
maximum readability.
Decreases
!5 NOISE REDUCTION SWITCH [NR] (p. 77)
Push to turn DSP noise reduction ON or OFF.
!6
Lights green when the squelch opens, or a signal is
mit in the satellite mode.
Blinks green when an off-frequency signal is re-
ceived, depending on the "FM/DV Center Error"
option in the Set mode. (p. 162)
!7
SQUELCH CONTROL [RF/SQL]
Rotate to adjust the RF gain and squelch threshold
level on the SUB Band.
The squelch stops noise output to the speaker
when no signal is received. (closed condition)
See o on page 2 for details.
3
!5
!4
!3 8
!6
!7
!8
!9 @0
@1 @2
[NR] (!5 ) .
Increases
@3
@4
@5
@6
@7 @8
!8
Rotate to adjust audio output level to the speaker or
headphones on the SUB Band.
!9 MIC GAIN CONTROL [MIC GAIN] (p. 46)
Rotate to adjust the microphone gain.
be independently adjusted in the tone control Set mode.
(p. 169)
How to set the microphone gain.
Set the meter function to ALC. (p. 45) While speak-
ing at normal voice level, adjust the [MIC GAIN]
control so that in the SSB or AM modes, the ALC
meter swings within the ALC range.
Recommended level for
Icom microphones
@0 RF POWER CONTROL [RF POWER] (p. 46)
Rotate to continuously vary the RF output power.
Decreases
HF/50 MHz
144 MHz
-
430 MHz
1200 MHz
@1 CW PITCH CONTROL [CW PITCH]
Rotate to shift the received CW audio pitch and the
CW sidetone pitch without changing the operating
frequency.
proximately 5 Hz steps.
Lower pitch
Decreases
Increases
Increases
2 to 100 W
(AM: 2 to 30 W)
2 to 100 W
2 to 75 W
1 to 10 W
Higher pitch
-
Need help?
Do you have a question about the IC-9100 and is the answer not in the manual?