Preparation For Sending Files Using Wsd - Ricoh 917F Operating Instructions Manual

Preparation for Sending Files Using WSD

To send scanned files using WSD, you must first perform the following:
• Check the machine is properly connected to the network
• Configure the network settings in [System Settings]
• Enable WSD using Web Image Monitor
• Register the machine to a client computer
Checking the machine is properly connected to the network
Check that this machine is properly connected to the network.
For details about how to connect this machine to a network, see "Connecting to the Interfaces", Network
and System Settings Guide.
Configuring the network settings in [System Settings]
Configure the network settings in [System Settings] according to your environment and how you will be
using the machine.
The following procedure explains connecting this machine to an IPv4 network using Ethernet cable.
Note that the settings you must configure will vary depending on your operating environment. For details
about network settings and configuration procedures, see "Network Settings Required to Use WSD
Scanner", Network and System Settings Guide.
1. Press the [User Tools/Counter] key, select [System Settings], and then press the [OK] key.
The System Settings screen appears.
2. Select the [Interface Settings], and then press the [OK] key.
Before Sending Scan Files Using WSD
3
83