Home Position; Home Position Parameter List - Ricoh 917F Operating Instructions Manual

Home Position

Specify the type of original immediately after the power is turned on and when [Clear Modes] key is
pressed.
Home Position
• Image Density
For details about Image Density, see "Image Density (Contrast)".
• Resolution
For details about Resolution, see "Resolution".
• Original Type
For details about Original Type, see "Original Type".
• Transmission Mode
For details about Transmission Mode, see "Transmission Modes".
• Label Insertion
For details about Label Insertion, see "Label Insertion".
• Fax Header
For details about Fax Header, see "Fax Header Print".
• p.17 "Transmission Modes"
• p.41 "Original Type"
• p.42 "Resolution"
• p.43 "Image Density (Contrast)"
• p.108 "Fax Header Print"
• p.110 "Label Insertion"

Home Position Parameter List

For details about setting parameters, see "Parameter Settings".
Do not change switches other than those listed.
Switch: 00, Bit: 3, 2, 1
Allows one of five image density steps to be set as the home position.
• 000: Normal density
• 001: The lightest density
• 010: The darkest density
Home Position
6
237