Wsmfp - Ricoh 917F Operating Instructions Manual

Interface name
ether
wlan
Address configuration
Use the following command to configure a WINS server IP address:
wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IP address.
• Use the "secondary" command to configure a secondary WINS server IP address.
• Do not use "255.255.255.255" as the IP address.
NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name
ether
wlan

wsmfp

Use the "wsmfp" command to view and configure WSD (Device), WSD (Printer) and WSD (Scanner)
settings.
View settings
msh> wsmfp
Comment settings
msh> wsmfp comments "comment"
• If you do not specify a comment, current setting is displayed.
Location configuration
msh> wsmfp location "location"
• If you do not specify a comment, current setting is displayed.
Remote Maintenance by telnet
Interface configured
Ethernet interface
IEEE 802.11 interface
Interface configured
Ethernet interface
IEEE 802.11 interface
4
193