Ricoh 917F Operating Instructions Manual page 1026

Message
add_sess_IPv6: community <community name>
already defined.
add_sess_IPX: bad trap addr: <IPX address>
community <community name>
add_sess_IPX: community <community name>
already defined.
adjust time server <NTP server name> offset: xx sec. ncsd tells you the timing of the NTP server and
Attach FileServer=<file server>
Attach to print queue <print queue name>
centrod is disabled.
child process exec error! <process name>
Connected DHCPv6 server <IPv6 address>
connection from <IP address>
Could not attach to FileServer <error number>
Could not attach to PServer <print server>
Problem and solutions
The same community name already exists. Use
another community name.
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
The same community name already exists. Use
another community name.
whether or not the time system clock is set.
Connection to the file server as the nearest server
has been established.
(In the print server mode) Attached to the print
queue.
Communication via parallel connections
unavailable because centrod is disabled in the
security mode.
Enable centrod in the security mode.
The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
The IP address was successfully received from the
DHCPv6 server.
A user logged in from the host <IP address>.
(In the remote printer mode) Connection to the file
server has not been established. The file server has
refused the connection. Check the file server
configuration.
(In the remote printer mode) Connection to the print
server has not been established. The print server
has refused the connection. Check the print server
configuration.
Message List
4
217