Wiconfig - Ricoh 917F Operating Instructions Manual

wiconfig

Use the "wiconfig" command to make settings for IEEE 802.11.
View settings
msh> wiconfig
View IEEE 802.11 settings
msh> wiconfig cardinfo
• If IEEE 802.11 is not working correctly, its information is not displayed.
Configuration
msh> wiconfig "parameter"
Parameter
mode {ap|802.11adhoc}
ssid "ID value"
channel frequency "channel no."
key "key value" val [1|2|3|4]
Value configured
You can set the infrastructure mode (ap) or the 802.11 Ad
hoc mode (802.11adhoc).
The default is the infrastructure mode.
You can specify an SSID in infrastructure mode. The
characters you can enter in the SSID string are ASCII
0x20-0x7e (32 bytes). If you do not specify a character
string, the machine will connect to the nearest access point.
The default SSID is blank.
In 802.11 ad hoc mode, you can select a channel between
1 and 14, or 36, 40, 44, or 48.
Be sure to set the same channel for all ports that will transmit
and receive data.
The default is "11".
You can specify the WEP key when entering in hexadecimal.
With a 64-bit WEP, you can use 10 digit hexadecimals. With
a 128-bit WEP, you can use 26 digit hexadecimals.
Up to four WEP keys can be registered. Specify the number
to be registered with "val".
When a WEP is specified by key, the WEP specified by key
phrase is overwritten.
To use this function, set the same key number and WEP key
for all ports that transmit data to each other. Put "0x"on the
front of WEP key.
Remote Maintenance by telnet
4
189