Image Density (Contrast) - Ricoh 917F Operating Instructions Manual

1. Press the [Resolution] key to switch between resolutions.
The indicators above the key show the current selection.
When both indicators are unlit, Standard is selected.
• If the other party's machine does not support the resolution at which you are sending, this machine
automatically switches to a resolution that is supported. You can check the resolution at which you
actually sent by printing the Journal. For details about printing the Journal, see "Printing the Journal".
• The machine supports reception at both Standard and Detail resolution.
• You can set the resolution type that is selected right after the machine is turned on or whenever the
[Clear Modes] key is pressed. See "Setting Transmission Function Defaults (Home Position)".
• When using Internet Fax transmission, documents are sent at "Detail" resolution, even if you have
specified "Fine". To send a document at "Fine", configure the Full Mode when registering the
destinations in the Address Book. See "T.37 Full Mode".
• p.34 "T.37 Full Mode"
• p.98 "Setting Transmission Function Defaults (Home Position)"
• p.163 "Printing the Journal"

Image Density (Contrast)

Adjust the image density at which the originals are scanned.
Use the [Image Density] key to vary the image density within 5 levels.
BRJ026S
Scan Settings
1
43